Description
Mahr
Pocket Surf IV Portable Surface Roughness Gauge
A pocket-sized economically priced, completely portable instrument which performs traceable surface roughness measurements on a wide variety of surfaces; can be used confidently in production, on the shop floor and in the laboratory.
Features:
- Solidly built, with a durable cast aluminum housing, to provide years of accurate, reliable surface finish gaging
- Can be used to measure any one of four, switch selectable, parameters:
Ra – Average roughness
Rmax/Ry – Max/Min Roughness Depth (DiN)
RZ - Then review any of the parameters after the measurement is complete
- Selectable traverse length 1, 3 or 5 cut-offs of 0.8 mm/0.030″
- Operates in any position – horizontal, vertical, and upside down
- Four switchable probe positions – axial (folded) or at 90°, 180° or 270°
- Even difficult-to-reach surfaces such as inside and outside diameters are accessible
- MarConnect data output for easy SPC-processing that is compatible with the most com-mon data processing systems
- Easy-to-read LCD readout pre-sents the measured roughness value, in microinches or micro-meters, within half a second after the surface is traversed.
- Out-of-range (high or low) and “battery low” signals are also displayed
- Improved digital calibration pro-cess eliminate screwdrivers and potentiometers to simplify and enhance the calibration process
- Improved battery life with easy to replace standard 9V battery
- Built in digital output.
- Supplied with general purpose probe. For most surface roughness applications. Has a 90° conical diamond stylus.
# 2236687 – Adjustable Height Stand with Swivel
A compact, convenient fixture with an adjustable bracket to hold the Pocket Surf, anywhere within a 360° rotation, for making measurements on a surface plate or on any suitable, flat working surface.
# EAS-2496 – Height Stand
A compact, convenient fixture with a bracket to hold the Pocket Surf gage. Designed for making measurements on a granite surface plate or on any suitable, flat working surface to a maximum height of about 111mm/4.375″.
# EAS-3048 – Mounting Bracket Swivel Fixture
For mounting the Pocket Surf to most standard height gages.
The bracket includes a rectangular bar that is 11.5 mm x 6.35 mm (0.45″ x 0.25″) to fit the holder of the height gage. A swivel feature is included to permit the Pocket Surf to be set anywhere within a 360° rotation.
# EGH-1020 – Transverse Chisel Probe
For gaging sharp edges or small O.D.’s where probe is aligned with (in 180° or closed position) to axis of traverse. 90° sapphire chisel, 10 μm./ .0004″ radius.
# EGH-1021 – Small Bore Probe
For gaging small bores (3,2 mm/ .125″ minimum I.D.) up to a depth of 19 mm/ .75″.
With a 90° conical diamond stylus, 10 μm/ .0004″ radius.
# EGH-1028 – Groove Bottom Probe
For measuring the bottom of grooves, recesses and small holes to depths of 6.35 mm/ .25″
Also used for short lands and shoulders. With 90° conical diamond stylus, 10 μm/ .0004″ radius.
NOTE: Small Bore and Groove Bottom Probes can only be used in 180° position with the Pocket Surf unit supported in a height stand or other fixture.
