Shimpo DT-311J NEMA 4X Stroboscope for Harsh, Wet Work Areas

$0.00

Category: SKU: SKU 1308

Description

Shimpo Instruments | NIDEC-SHIMPO AMERICA

Model DT-311J, NEMA 4X Stroboscope for Harsh, Wet Work Areas

DT-311J Stroboscope

Series DT-311J NEMA 4X Stroboscope for Harsh, Wet Work Areas

Where powerful illumination and rugged speed measuring accuracy is required for the textile industry, the DT-311J will perform where other stroboscopes will not. The DT-311J is used to set injection timing, injection pressure, timing of shedding and weft running time of weaving machinery. Units combine rugged NEMA 4X (IP65) housing with high performance accuracy, special phase shifting, with shock absorbing components and top mounted handle, allows the equipment operator maximum flexibility when setting the timing of weaving machinery.

Features

  • Internal signal “MODE” (flash), allow manual control and display of flash rate (rpm), deg (flash delay angle in degrees)
  • External triggering control, automatically synchronizes to an input signal
  • Phase “SHIFT” switch, single touch – changes flash timing, 0 – 359 degrees
  • “ZERO” setting control, zeroing at any angle is easy-single touch
  • Long life flashtubes, flash rates of 200-1500 fpm, the DT-311J flash tubes are designed for extra long life
  • Angle division “DIV”, permits special flash interval ratio settings: 1/1, 1/2, 1/3, 1/4, and 2/4 flashes per rotation
  • LIMTED RANGE: 200-1,500 RPM/FPM
  • Accepts external trigger input and provides synchronizing pulse output
  • Water & Dustproof housing (IP65)
  • Phase shift for best view and flash photography
  • Hand-held or tripod operation
  • Easy-to-operate controls
  • Easy-to-read LED display
Specifications
Flash Range 200-1,500 FPM
Internal Signal Range 200 to 1,500 FPM
Phase Shift 0° – 359° / 1° increments
Accuracy ±1 digit
Flash Rate/Phase Angle Setter Rotary dial
Display 4 digit, 10mm high Red LED
Divide Ratio 1/1, 1/2, 1/3, 1/4, 2/4 with shift
Input Signal High level: 5-24 V pulse
Low Level: 0-1 V pulse. 2 msec minimum. Impedance less than 10k Ω
Input Impedance 47k
Display Mode Phase shift (degree), Tachometer
Flashtube Xenon lamp, max 10 W at 1,5000 rpm
Flashtube Life 1,200 hours at 1,500 rpm
Power Requirements 115 V or 230 V AC (specify), 50/60 Hz, 30 VA
Power Consumption 20VA max
Operating Temp 32 to 104 °F (0 to 40 °C)
Dimensions 149w x 174h x 214d mm
Weight 4.2 lb (1.9 Kg)
Warranty 2 years
Included Accessories 19.68’ (6m) input/power cable with connector, rubber strobe guard with handle