Description

Renishaw

Pre-owned: An item that has been used previously.

The item may have some signs of cosmetic wear, but is fully operational and functions as intented.

PHC10-2 head controller receives instructions from the CMM control

PHC10-2 motorised head controller

The PHC10-2 controls all head functions and reports system status to the CMM:

Drives PH10 (PH10T, PH10M or PH10MQ) to position – sent either from the HCU1 or CMM
Checks and reports position
Flags up errors, e.g. failure to reach position, obstruction before or after locking etc.

The PHC10-2 does not process any of the probe sensor signals.

These are railed clean through the heads axes and controller to the probe interface.

Length	220 mm
Width	289.3 mm
Height	88 mm
Weight	2.86 kg
Data transmission	RS232 or IEEE
Current consumption (at 240 V)	Less than 500 mA
Voltage range	85 V to 264 V 47 Hz to 66 Hz automatic selection
Input connectors	15-way ‘D’
Probe output connectors	7-pin DIN or 9-way ‘D’ type
Mounting	Rack mounted or stand alone
Hand control unit	HCU1 only